Étape 2: Circuit électronique
Le circuit est simple à faire, avant de le rendre, il suffit de connecter un bouton, l’orateur et une LED à l’Arduino pour voir si elles fonctionnent. Utilisez une maquette d’interconnecter toutes les pièces mentionnées.
- Raccordez le GND de l’Arduino sur la broche (-) de la maquette
- Maintenant connecter une résistance de 10K Ohms à une broche du bouton
- Brancher la fiche adverse du bouton sur une broche de signal dans l’Arduino (Digital Pin # 4)
- [Facultatif] Se connecter à la cathode d’une LED à la terre de la maquette et de l’anode à la broche numérique #13.
- Répétez les étapes 7 fois plus pour arriver à un circuit simple qui a des boutons qui sont connectés à l’Arduino, basé sur ces boutons, nous allons sélectionner des fréquences de la bibliothèque « pitches.h ».
- [Facultatif] Couper le câble négatif de la batterie vers le GND de l’Arduino et connecter un commutateur Si vous pouvez passer votre E-piano on ou off.
- Enfin, branchez la borne positive de l’orateur à la goupille PWM #3 et le fil négatif à GND.
Après avoir connecté votre premier bouton uniquement, utilisez le Code suivant de Bouton Arduino (exemple) pour tester si votre circuit ne fonctionne pas très bien ou pas.
La figure montre le circuit schématique et comment chaque bouton est associé à l’Arduino. Votre enfin le circuit doit ressembler à elle. Vous pouvez aussi avoir des LEDs ajoutés à chaque bouton.
/* Button
Turns on and off a light emitting diode(LED) connected to digital pin 13, when pressing a pushbutton attached to pin 2.
The circuit: * LED attached from pin 13 to ground * pushbutton attached to pin 2 from +5V * 10K resistor attached to pin 2 from ground
* Note: on most Arduinos there is already an LED on the board attached to pin 13.
created 2005 by DojoDave modified 30 Aug 2011 by Tom Igoe
This example code is in the public domain.
http://www.arduino.cc/en/Tutorial/Button */
const int buttonPin = 4; // the number of the pushbutton pin const int ledPin = 13; // the number of the LED pin
// variables will change: int buttonState = 0; // variable for reading the pushbutton status
void setup() { // initialize the LED pin as an output: pinMode(ledPin, OUTPUT); // initialize the pushbutton pin as an input: pinMode(buttonPin, INPUT); }
void loop() { // read the state of the pushbutton value: buttonState = digitalRead(buttonPin);
// check if the pushbutton is pressed. // if it is, the buttonState is HIGH: if (buttonState == HIGH) { // turn LED on: digitalWrite(ledPin, HIGH); } else { // turn LED off: digitalWrite(ledPin, LOW); } }