Étape 3: Commandes AT
Avant d’établir la connexion entre le module Bluetooth et le PC, nous avons besoin de télécharger le code, à l’Arduino qui met le HC05 dans en mode commande. Le code se trouve ci-dessous
#include <SoftwareSerial.h> SoftwareSerial BTSerial(10, 11); // RX | TXvoid setup(){ pinMode(9, OUTPUT); // this pin will pull the HC-05 pin 34 (key pin) HIGH to switch module to AT mode digitalWrite(9, HIGH); Serial.begin(9600); Serial.println("Enter AT commands:"); BTSerial.begin(38400); // HC-05 default speed in AT command more }void loop() { // Keep reading from HC-05 and send to Arduino Serial Monitor if (BTSerial.available()) Serial.write(BTSerial.read()); // Keep reading from Arduino Serial Monitor and send to HC-05 if (Serial.available()) BTSerial.write(Serial.read()); }